Product Information

Drive Specifications

Interfaces

Installation and Configuration

Drive Operation

Tips and Techniques

Software

Maintenance

Troubleshooting

Warranty and Support

Release Notes

Discontinued Products

 

 

 

 

8.Look at the Install Recommendation printout to see whether the jumper should be set to the Master or Slave position, then set the jumper on the back of the hp dvd-writer drive to the recommended position.

NOTE: Jumpers are small caps that fit over pairs of pins on the back of the hp dvd-writer drive. Jumpers can be pulled off or replaced with needle- nose pliers.

9.If your computer uses rails, attach the rails that came with the computer to the sides of the hp dvd-writer dvd100i drive (see Figure 19).

Some computers use rails instead of screws to hold the drive in place.

NOTE: You can tell if your computer uses rails by looking at the other drives installed in your computer.

Figure 19 Rails for Mounting the Drive

10. Slide the hp dvd-writer drive partially into the bay.

Figure 18 Setting Jumpers on the Drive

hp dvd-writer dvd100i Technical Support Solutions Guide 10/25/01

Installing the hp dvd-writer dvd100i Drive

⇐

⇒

38