To connect the Ethernet connector to the network:
1Plug the network cable into the Ethernet connector (A) on the back of the PC.
WARNING: Do not plug the telephone service line cable or modem cable into the Ethernet connector. Although the plug looks similar to the plug on the Ethernet cable, they are not the same.
2Plug the other end of the Ethernet cable into a 10BaseT or a 100BaseT port on the network hub.
NOTE: Hubs are devices that can connect PCs to a network.
3With the PC turned on, check the lights next to the Ethernet connector for status:
•ACTIVITY — Lit yellow during network data transfer activity
•LINK — Lit green with valid network connection
turning on your pc for the first time
After you have completed the steps on the quick setup poster, you are ready to turn on your PC.
1Press the Power button on the monitor.
2Press the On button (A) on the front of the PC (see the following figure).
3Press the Power button on the speakers, if they are present.
A
4Click an option to select your language (if applicable for your model). Click OK and then confirm your selection by clicking Yes. Wait until the PC makes preparations. (It may take up to 30 minutes to set up the language on the PC.)
5Set up Microsoft® Windows® by following the onscreen instructions.
10user’s guide
