HP J6400 manual Back view of the device

•If your computer has two phone ports, set up the device as described below.

Figure 8-13 Back view of the device

1	Telephone wall jack
2	Use the phone cord supplied in the box with the device to connect to
	the 1-LINE port

3 Parallel splitter

4 Computer with modem

5 Telephone

To set up the device on the same phone line as a computer with two phone ports

1.Remove the white plug from the port labeled 2-EXT on the back of the device.

2.Find the phone cord that connects from the back of your computer (your computer dial-up modem) to a telephone wall jack. Disconnect the cord from the telephone wall jack and plug it into the port labeled 2-EXT on the back of the device.

3.Connect a phone to the "OUT" port on the back of your computer dial-up modem.

4.Using the phone cord supplied in the box with the device, connect one end to your telephone wall jack, then connect the other end to the port labeled 1-LINE on the back of the device.

NOTE: If you do not use the supplied cord to connect from the telephone wall jack to the device, you might not be able to fax successfully. This special phone cord is different from the phone cords you might already have in your home or office.

5.If your modem software is set to receive faxes to your computer automatically, turn off that setting.

NOTE: If you do not turn off the automatic fax reception setting in your modem software, the device will not be able to receive faxes.

6.Turn off the Auto Answer setting.

7.Run a fax test.

Set up faxing for the device 105