5.14 Power Supply

CAUTION: Do not handle or carry the power supply by the wiring harness. This can cause damage to the power supply and wiring harness.

1.Prepare the expansion base for disassembly (Section 5.3).

2.Remove the tray (Section 5.4).

3.Remove the rear bezel (Section 5.6).

4.Remove the top cover (Section 5.8).

5.Disconnect the power supply cable connected to the backplane ➊.

6.Remove the four screws ➋ that secure the power supply to the base cover (Figure 5-29).

Figure 5-29.Disconnecting the Power Supply Cable and Removing the Power Supply Screws

CAUTION: Make sure the power supply cables are properly unclipped from the backplane before disconnecting the power supply cables.

Removal and Replacement Procedures

5-29