7.Remove the six screws ➊ and ➋ that secure the MultiBay and control panel to the base cover (Figure 5-25).

NOTE: The screws removed in this step are two different sizes: four screws ➊ are Torx T10 screws; the other two screws ➋ are Torx T15 screws. Be sure to install these screws in the correct locations when reinstalling the MultiBay.

8.Slide the MultiBay forward ➌ and then left it out of the base cover ➍.

Figure 5-25.Removing the MultiBay and Control Panel

Reverse the removal procedure described above to install the MultiBay and control panel into the base cover.

Removal and Replacement Procedures

5-25

Page 55
Image 55
HP m300 manual Removing the MultiBay and Control Panel