HP NetServer NetRAID-4M manual

HP NetRAID-4M Cluster Services Installation Guide Hardware, Drivers and Utilities

CAUTION	Connecting to adjacent channels, i.e.: 0 and 1, or 2 and 3, on the HP
	NetRAID-4M requires SCSI offset cables. Do NOT try and force connecting
	any other SCSI cables to channels next to each other or the controller may
	become damaged.

30.As shown in the graphic above, using the appropriate SCSI cables, connect the Server A HP NetRAID-4M Channel-0to an HP RackStorage/12 unit rear left SCSI card port.

31.Connect the Server A HP NetRAID-4M Channel-1to a different HP RackStorage/12 unit, also to a rear left SCSI card port.

32.Connect the Server B HP NetRAID-4M Channel-0to the same HP RackStorage/12 unit as in step 30, this time, to the rear right SCSI card port.

33.Connect the Server B HP NetRAID-4M as in step 31, to the rear right SCSI card

Channel-1to the same HP RackStorage/12 unit port.

NOTE If more than two RS/12 SCSI cabinets are to be added to this cluster, attach other channels of the HP NetRAID-4M in a pattern consistent with the above diagram.

34.Power on all HP RackStorage/12 units.

35.Verify that the green indicator lights appear both on the front of the disk drives and on the SCSI connector card backplane of each HP RackStorage/12 before continuing.

9