Photosmart HP the up setting Finish
Chapter 2
Since your computer
Back view of the HP Photosmart
1Telephone wall jack
2Use the phone cord supplied in the box with the HP Photosmart to connect to the
3Computer with modem
To set up the HP Photosmart with a computer
1.Remove the white plug from the port labeled
2.Find the phone cord that connects from the back of your computer (your computer
3.Using the phone cord supplied in the box with the HP Photosmart, connect one end to your telephone wall jack, then connect the other end to the port labeled
NOTE: If you do not use the supplied cord to connect from the telephone wall jack to the HP Photosmart, you might not be able to fax successfully. This special phone cord is different from the phone cords you might already have in your home or office.
4.If your modem software is set to receive faxes to your computer automatically, turn off that setting.
NOTE: If you do not turn off the automatic fax reception setting in your modem software, the HP Photosmart will not be able to receive faxes.
5.Turn on the Auto Answer setting.
6.(Optional) Change the Rings to Answer setting to the lowest setting (two rings).
7.Run a fax test.
When the phone rings, the HP Photosmart will answer automatically after the number of rings you set in the Rings to Answer setting. Then it will begin emitting fax reception tones to the sending fax machine and receive the fax.
Case H: Shared voice/fax line with computer
If you receive both voice calls and fax calls at the same phone number, and you also have a computer
Since your computer
There are two different ways to set up the HP Photosmart with your computer based on the number of phone ports on your computer. Before you begin, check your computer to see if it has one or two phone ports.
•If your computer has only one phone port, you will need to purchase a parallel splitter (also called a coupler), as shown below. (A parallel splitter has one
20 Finish setting up the HP Photosmart