HP D3K73UT#ABA, Pro 3515 E3S87UTABA, D3K31UTABA, 3500p D8C44UTABA, D8C44UT#ABA manual Cable Management

10.Connect external cables to the installed card, if needed. Connect internal cables to the system board, if needed.

11.Reconfigure the computer, if necessary.

Cable Management

Always follow good cable management practices when working inside the computer.

●Keep cables away from major heat sources like the heat sink.

●Do not jam cables on top of expansion cards or memory modules. Printed circuit cards like these are not designed to take excessive pressure on them.

●Some flat ribbon cables come prefolded. Never change the folds on these cables.

●Never bend a SATA data cable tighter than a 30 mm (1.18 in) radius.

●Never crease a SATA data cable.

●Do not rely on components like the drive cage, power supply, or computer cover to push cables down into the chassis. Always position the cables to lay properly by themselves.

When removing the power supply power cable from the P1 connector on the system board, always follow these steps:

1.Squeeze on the top of the retaining latch attached to the cable end of the connector (1).

2.Grasp the cable end of the connector and pull it straight up (2).

CAUTION: Always pull the connector - NEVER pull on the cable. Pulling on the cable could damage the cable and result in a failed power supply.

100 Chapter 8 Removal and Replacement Procedures – Small Form Factor (SFF) Chassis