Chapter 1

Install Tray 2

NOTE: This feature is available with some models of the printer.

Tray 2 can hold up to 250 sheets of plain paper. For ordering information, see HP supplies and accessories.

To install Tray 2

1.Unpack the tray, remove the packing tapes and materials, and move the tray to the prepared location. The surface must be sturdy and level.

2.Turn off the printer, and disconnect the power cord.

3.Set the printer on top of the tray.

CAUTION: Be careful to keep your fingers and hands clear of the bottom of the printer.

4.Connect the power cord and turn on the printer.

5.Enable Tray 2 in the printer driver. For more information, see Turn on accessories in the printer driver.

To load Tray 2

1.Pull the tray out of the printer by grasping under the front of the tray.

2.Insert the paper print-side down in the center of the tray. Make sure the stack of paper aligns with the line on the width guide, and does not exceed the line marking on the guide.

NOTE: Tray 2 can be loaded only with plain paper.

30 Get started