Removing a Bezel Blank

On some models, there is a bezel blank covering the optical drive bay that must be removed before installing a drive. To remove a bezel blank:

1.Remove the access panel and front bezel.

2.Push outward on the two retaining tabs that hold the bezel blank in place (1) then pull the blank inward to remove it (2).

Figure 2-6Removing a Bezel Blank

Replacing the Front Bezel

Insert the three hooks on the bottom side of the bezel into the rectangular holes on the chassis (1) then rotate the top side of the bezel onto the chassis (2) and snap it into place.

Figure 2-7Replacing the Front Bezel (shown with optical drive installed)

Removing a Bezel Blank 11