To connect the Ethernet connector to the network:

1Plug the network cable into the Ethernet connector (A) on the back of the PC.

WARNING: Do not plug the telephone service line cable or modem cable into the Ethernet connector. Although the plug looks similar to the plug on the Ethernet cable, they are not the same.

2Plug the other end of the Ethernet cable into a 10BaseT or a 100BaseT port on the network hub.

NOTE: Hubs are devices that can connect PCs to a network.

3With the PC turned on, check the lights next to the Ethernet connector for status:

ACTIVITY — Lit yellow during network data transfer activity

LINK — Lit green with valid network connection

turning on your pc for the first time

After you have completed the steps on the quick setup poster, you are ready to turn on your PC.

1Press the Power button on the monitor.

2Press the On button (A) on the front of the PC (see the following figure).

3Press the Power button on the speakers, if they are present.

A

IN

10user’s guide