Chapter 3 | Installing and Configuring |
SCSI Configuration Utility
The HP Server uses the SCSISelect Utility to verify or modify the SCSI controller board settings for the devices connected to the active SCSI connector on the SCSI controller board. If you need to verify or modify SCSI controller settings, or if you need to
NOTE | You typically would not need to use this utility unless you are an experienced |
| administrator or have been requested to do so by a support provider. |
During the boot process the BIOS searches for SCSI devices and a specific message appears if there are devices connected to the SCSI controller board, as shown below. The SCSI controller can provide the bus, device, and channel configurations when active on screen.
To access the SCSISelect Utility, refer to the following instructions. 1. Boot or reboot the HP Server.
If you are already in the boot process, you should see the following message appear.
<<<Press <Ctrl A> for SCSISelect Utility!>>>
2. Press Ctrl + A to enter the utility.
The SCSISelect Utility appears on screen.
3.Use the arrow keys to move the cursor, press Enter to select an option, or press Esc to exit.
4.To change SCSI controller settings, select “Configure/View Host Adapter Settings.”
This menu allows you to configure the SCSI controller ID settings or other advance controller settings.
5. Select “SCSI Disk Utilities” to format a hard disk or change hard disk parameters:
CAUTION
48