Chapter 7 | Replacing Parts |
The SCSI backup tape drive should not be terminated, but if it is remove the termination jumper. The default SCSI address for HP backup tape drive is normally set to ID address = 3.
3.Attach the backup tape drive to third mounting tray using the four screws on the sides of the tray.
The optional HP SureStore DAT 24i backup tape drive normally comes with 5¼ inch mounting brackets installed on the tape drive. If not, follow the instructions provided with the tape drive to connect the 5¼ inch mounting brackets to the tape drive, before installing the tape drive into the third drive tray.
4.Guide the backup tap drive tray into the chassis opening, with the cable connectors toward the rear of the chassis.
5.At the rear of the backup tap drive tray, carefully connect the power and data cables.
The optional HP backup tape drive comes with a
6.Replace the upper bezel.
7.Replace the left side cover.
8.Replace the external cables and power cord.
9.Power on the Server as described in Chapter 1, “Controls and Indicators.”
Removing a Hard Disk Drive (Tray Mounted)
This procedure is used to remove the third hard disk drive (HDD) mounted in the fourth shelf.
1.If the Server is operating, power down the Server.
Refer to Chapter 1, “Controls and Indicators” for instructions.
2.Disconnect the power cord and any external cables connected to the Server. If necessary, label each one to expedite
3.Remove the left side cover.
4.At the rear of the HDD tray, carefully disconnect the power and data cables.
5.Remove the hard disk drive (HDD):
a.Press in on both release tabs to release the HDD tray.
b.Pull the HDD tray out of the chassis.
c.Remove the four screws, from below the HDD tray.
6.Place the HDD in an
78