Chapter 7 | Replacing Parts |
Figure
7.Remove the flexible disk drive from the tray.
8.Place the flexible disk drive in an
Replacing the Flexible Disk Drive
1.If not already mounted, insert the new drive in the tray (pin side first), and then replace the side screws.
2.With the cable connectors toward the rear of the chassis, slide the FDD assembly all the way into the chassis, until the FDD assembly snaps into place.
The flexible disk drive is only mounted in the top shelf (shelf 1).
3.At the rear of the flexible disk drive, carefully connect the power and data cable.
4.Replace the upper bezel.
5.Replace the left side cover.
6.Replace the external cables and power cord.
7.Power on the Server as described in Chapter 1, “Controls and Indicators.”
Removing the
16.If the Server is operating, power down the Server.
Refer to Chapter 1, “Controls and Indicators” for instructions.
17.Disconnect the power cord and any external cables connected to the Server. If necessary, label each one to expedite
18.Remove the left side cover.
Refer to “Opening and Closing the HP Server” in Chapter 3.
19.Remove the upper bezel.
Refer to “Opening and Closing the HP Server” in Chapter 3.
20.At the rear of the
21.Remove the
Press in on both release tabs to release the
75