Chapter 7

Replacing Parts

Figure 7-17. Removing the Power Supply

Replacing the Power Supply

1.Insert the new power supply and replace the screw securing it on the inside of the chassis.

2.Replace the remaining screws securing the power supply.

3.Reconnect all internal power supply connectors.

4.Replace the left side cover.

5.Replace the external cables and power cord.

6.Select the correct voltage setting for your country.

7.Power on the Server as described in Chapter 1, “Controls and Indicators.”

Battery

Removing the Battery

1.If the Server is operating, power down the Server.

Refer to Chapter 1, “Controls and Indicators” for instructions.

2.Disconnect the power cord and any external cables connected to the Server. If necessary, label each one to expedite re-assembly.

3.Remove the cover.

WARNING The power supply will continue to provide standby current to the HP Server until the power cord is disconnected from the AC power source.

4.Lay the Server on its side (components showing) for better access to the battery, especially when it is released from the socket.

5.If necessary, remove any accessory boards or SCSI cables that prevent access to the battery socket.

91