Chapter 6 | Maintenance and Troubleshooting |
LEDs are not lit on the NIC
No lit LEDs probably indicates a bad network cable, hub connection, or other network error.
1.Ensure that the cabling is installed correctly:
a.Try another known good network cable.
b.Try another network connection (another hub, switch, etc.)
c.Connect the NIC to a known good network connection.
If there are still no lit LEDs, do the following:
2.Power off the HP Server and unplug the power cord/s from the power source. Remove the left side cover.
NOTE | The HP Server tc2110 has an integrated NIC so skip the following steps unless a PCI NIC |
| is installed in the server. |
|
|
CAUTION Always wear an antistatic wrist guard when working inside the HP Server.
3.Locate the NIC and reseat it in its slot.
4.Replace the covers; plug in the power cord/s to a power source, and power on the HP Server.
5.If the problem persists, perform previous step 2 and 3 but move the NIC to another slot.
6.Replace the covers; plug in the power cord/s to a power source, and power on the HP Server.
If the problem persists, contact the HP Customer Support Center for further troubleshooting assistance before replacing any parts.
72