HP UX Kerberos Data Security Software manual Installing the Server, Step

Installing the Kerberos Server v3.1

Installing the Server

		Installing the Server
		To install the Kerberos server, complete the following steps:
Step	1.	Insert the software media (tape or disk) in the appropriate drive.
Step	2.	Type the swinstall command at the HP-UX prompt.
		For more information on the swinstall command, type man 1M
		swinstall at the HP-UX prompt.
Step	3.	In the Specify Source window, select the appropriate path of the depot
		and click OK.
Step	4.	Highlight T1417AA in the Software Selection dialog box, and select
		Mark For Install from the Actions menu to install all filesets in the
		bundle.
Step	5.	When you have marked the product components you want to install,
		select Install (analysis) from the Actions menu.
Step	6.	When you have successfully completed the analysis, click OK in the
		Analysis dialog to load the Kerberos server filesets.

The swinstall utility loads the filesets. The estimated time for processing is 5 minutes.

If the installation is not successful, an error message is displayed. The cause of the failure will appear at the end of the /var/adm/sw/swagent.log file.

For more information, see Managing HP-UX Software with SD-UXat http://www.docs.hp.com.

Kerberos server v3.1 is ready for use.

To configure the server to act as either the primary security server or one of the secondary security servers, see Chapter 7, “Configuring the Primary and Secondary Security Server,” on page 95 for more information.

Chapter 2 39