3 Interface Devices and Mass-Storage Drives

SCSI / LAN Combo Board

External (8-bit) SCSI connector

By default, the internal SCSI bus is configured to run in Ultra-SCSI mode (providing a maximum band-width of 40 MB/s. The user may configure the SCSI system using the SCSI Configuration Utility, included in the system BIOS. This utility is described in more detail on page 77.

SCSI-configured-automatically (SCAM) support is provided at level 2, for Plug and Play. However, hot swap is not supported. The controller is BBS compliant.

The Ultra narrow 8-bit SCSI connector uses addresses ranging from 0 to 7. As with the 16-bit internal SCSI connector, the SCSI address 0 is used by the first SCSI hard disk drive and SCSI address 7 is reserved for the integrated SCSI controller (the default for wide and narrow SCSI devices).

SCSI / PCI LAN Combo Board Features

Interface

Features

 

 

PCI Interface

Full 32-bit DMA bus master.

 

 

 

Zero wait-state bus master data bursts.

 

 

 

Universal PCI bus voltage support.

 

 

SCSI Interface

16-bit single ended.

 

 

 

Automatically enabled active termination

 

 

 

Fast and Ultra SCSI data transfer capability.

 

 

 

SCSI TERMPWR source with auto-resetting circuit breaker

 

 

 

SCAM (SCSI Configured AutoMatically).

 

 

 

Serial NVRAM (Non-Volatile RAM) for configuration utility and SCAM.

 

 

 

Flash BIOS.

 

 

 

Fast and Ultra SCSI controlled by external SCSI cable detection.

 

Ultra speed requires 1.5m maximum SCSI bus.

 

 

60

Page 60
Image 60
HP XA External 8-bit Scsi connector, Scsi / PCI LAN Combo Board Features, Interface Features PCI Interface, Scsi Interface