NOTE

3 Interface Devices and Mass-Storage Drives

10BT/100TX LAN Controller

10BT/100TX LAN Controller

Certain models of the HP Kayak XA PC Workstation are supplied only with a 10BT/100TX LAN adapter which supports the following standards:

100Mbits per second over 2-pair, category-5, unshielded twisted pair (UTP), or shielded twisted pair (STP); 10 BaseT, 10 Mbits per second, ISO 8802-3 (IEEE 802.3 standard).

On the rear panel there is one RJ-45 connector. There is an LED which indicates the LAN connection status as follows:

•Off - when there is no Autonegotiation response (for example, when the LAN cable is not connected to the network HUB.

•Blinking - during Autonegotiation

•Green (ON) - the connection has passed the Autonegotiation and a link has been established between the LAN adapter and the network HUB/ Switch.

The LAN adapter contains a connector to which an internal LAN cable may be connected to the external start connector on the system board, necessary for the use of the Remote Power On feature, described in detail in the User’s Guide provided with the PC Workstation. The LAN adapter that uses the Remote Power On feature must be installed nearer the processors than any other supplementary LAN adapter card.

Internal LAN connector for External

Optional ROM Socket

Start (Remote On)

 

LAN cable connector (RJ-45)

Refer to the User’s Guide for details concerning system configuration changes necessary after installing a LAN adapter.

61