Configuring an ExpressCard

Install only the software required for the card. If you are instructed by the ExpressCard manufacturer to install device drivers:

Install only the device drivers for your operating system.

Support for ExpressCards is included in the operating system. Only install additional software if required. If in doubt, check with the vendor or contact HP support.

Inserting an ExpressCard

CAUTION: To prevent damage to the computer and external media cards, do not insert a PC Card into an ExpressCard slot.

CAUTION: To reduce the risk of damage to the connectors: Use minimal force when inserting an ExpressCard.

Do not move or transport the computer when an ExpressCard is in use. ExpressCard is a network device, shut down the ExpressCard before removing it from your computer.

NOTE: The following illustration may look slightly different than your device.

The ExpressCard slot may contain a protective insert. To remove the insert:

1.Press in on the insert (1) to unlock it.

2.Pull the insert out of the slot (2).

To insert an ExpressCard:

1.Hold the card label-side up, with the connectors facing the computer.

Using ExpressCards (select models only) 45

Page 55
Image 55
HP ZBook 15 Mobile manual Configuring an ExpressCard, Inserting an ExpressCard