Contact Humminbird | Humminbird 937C DF COMBO, 937C COMBO instruction

www..reelsche93x Man 531370-1mA - vs4atic.qxd 2/18/2005..com11:13 AM Page 91

Contact Humminbird®

Contact the Humminbird® Customer Resource Center

in any of the following ways:

By Telephone

(Monday - Friday 8:00 a.m. to 4:30 p.m. Central Standard Time):

1-800-633-1468

By e-mail

(typically we respond to your e-mail within three business days):

custserv@johnsonoutdoors.com

For direct shipping, our address is:

Humminbird®

Service Department

678 Humminbird® Lane

Eufaula, AL 36027 USA

Page 91

Image 91

Humminbird 937C DF COMBO, 937C COMBO manual Contact Humminbird

Contents

Page Thank YOU Table of Contents Menu System Start-Up Options Menu Contact Humminbird Dualbeam Plus Sonar Series IntroductionHOW the 900 Series Works Single Beam Sonar Multi-Media Card MMC/SD Slot MULTI-MEDIA Card MMC/SD Slot 900 Series has a wide variety of configurations Accessory BUSInstallation Overview Accessory Bus Basic installation tasks that you must perform include Control Head InstallationGimbal Mounting the Control Head Mounting Screws Washer Gimbal Mounting Bracket Cables Routed Near Mounting Bracket Back of Control Head IN-DASH Mounting the Control Head Temperature Plug Cable Connector Assembly to Back of Control Head Connecting the Control Head Power Cable to the Boat Transducer Installation Route the transducer cable Transom Transducer InstallationTo determine transducer mounting location Determine transducer mounting location Moves clockwise as the boat moves Corner of the template Normal Cavitation Confirm that the pivot angle has not changed Attaching the Bracket To attach the pivot to the transducer Dual frequency unit Force is necessary to pivot the assembly Order to gain access to the mounting screws, To route the transom transducer cable all transducers Trial installation Inside the Hull Transducer InstallationDetermine the transducer mounting location Inside the Hull Permanently mount the transducerRoute the cable Make sure the position of the transducer is marked Test and Finish the Transducer Installation Trolling Motor Transducer Installation Follow these steps to stem mount the GPS receiver Stem Mounting with AN Existing 1 14 Thread StemIf you have… Then use Hand-tighten only To the cable as shown Access Under Mounting Location Finish Routing the Cable and Check GPS Receiver Operation No Access Under Mounting Location Install the Speed accessory Speed Accessory InstallationHand tighten only Routing the speed cable to the control head Cleaning the Speed accessoryRotating Retaining Axial Clip to Remove Paddlewheel To test the installation Testing the System Installation Powering UP the Control Head Getting Started Using Your 900 SeriesSeries 937c DF Combo Title Screen Triplog WHAT’S on the Sonar Display Real Time Sonar RTS Window Understanding Sonar HistoryBottom Presentation KEY Functions POWER/LIGHT KEYMARK/GOTO key Info key Zoom +/- key Fishing requirements see View Menu Tab View KEYMenu KEY WAY Cursor Control KEY MARK/GOTO KEY View Preset KeysExit KEY Info KEY Navigation views ViewsViews and Readouts Sonar views Sonar Zoom View Sonar ViewSonar View Split Sonar View Sonar Zoom View Bird’s Eye View BIRD’S EYE View Chart View with Active Cursor Chart/Bird’s Eye Combo View 1112 Chart/Sonar Combo View Chart View with Cursor Present Chart Orientation Navigation Waypoints, Routes and Tracks To save the marked position as a waypoint Navigate to a Waypoint or Position Chart View with Grid Chart View with TargetADD a Waypoint Target or Trolling Grid Save or Clear a Current Track Press Menu Menu System START-UP Options Menu Sonar Tab, Normal ModeStart-Up Options Menu Simulator Exit Normal operation by powering your 900 Series offNormal Operation Simulator Self Test Accessory TestSelf Test Accessory Test System Status Sonar X-PRESS Menu GPS Diagnostic View Sensitivity Active SideSplit Position Lower Range To adjust the Upper RangeTo adjust the Lower Range Upper Range Sonar Colors Chart SpeedZoom Level Bottom Lock Navigation X-Press Menu Highlight Split Position on the Navigation X-Press Menu Clear Current Track Save Current TrackSave Current Route Remove Target Cancel NavigationRemove Grid Highlight Beam Select on the Sonar main menu Sonar Menu TABBeam Select To use Beam Select To turn Fish ID+ on or off To change the Fish ID Sensitivity settingFish ID+ Fish ID Sensitivity To change the Zoom Width To adjust the Bottom ViewBottom View Zoom Width Noise Filter KHZ SensitivityDepth Lines Surface Clutter Water Type MAX DepthTransducer Select Color BAR Temperature GraphNavigation Menu TAB Routes TracksWaypoints Track MIN Distance North ReferenceTrolling Grid Rotation Trackpoint Interval Export ALL NAV Data MAP DatumDelete ALL NAV Data To change the Map Borders setting Chart Menu TABChart Detail Level To change the Chart Detail Level setting Spot Soundings LAT/LON GridShaded Depth SET MAP Offset Alarms Menu TABClear MAP Offset Temp Alarm Depth AlarmFish ID Alarm LOW Battery Alarm To change the Off Course Alarm setting OFF Course AlarmArrival Alarm Drift Alarm To change the Alarm Tone setting Alarm ToneHighlight Alarm Tone on the Alarms main menu Units Depth Setup Menu TABTo change the Units Depth setting To change the Units Temp setting Language User ModeUnits Distance Units Speed To Restore Defaults Triplog ResetRestore Defaults To Reset Triplog To Select Readouts Default Sonar View Customized Sonar View Local Time Zone Depth OffsetTemp Offset Speed Calibration Position Format Daylight Saving Time To turn Nmea Output on or off Nmea OutputSonar Following Nmea sentences are output Highlight the View main menu tab Accessories Menu TABViews Menu TAB To Change the View Status of Any View Series Doesn’t Power Up TroubleshootingSeries Defaults to Simulator with a Transducer Attached Problem Possible Cause Display Problems Boat’s engine Finding the Cause of NoiseOther electronic devices Noise re-appears Humminbird Service Policy Year Limited Warranty Series Accessories Returning Your Unit for ServiceFor IN-WARRANTY service, complete the following steps Power Output Specifications Place on bottom of hull Appendix aAlign with transom Appendix B Contact Humminbird