2. Place the two ratchets, one on either side of the transducer knuckle, |
so that the beads on each ratchet line up with the desired position |
Transducer Knuckle Positions | Ratchets Placed in Position 1 |
number on the knuckle. If you are setting the ratchets at position 1, |
Knuckle
Beads
the beads on each ratchet will line up with the rib on the transducer |
knuckle to form one continuous line on the assembly. |
NOTE: The ratchets are keyed; make sure that the square teeth on each ratchet face the square teeth on the transducer knuckle, and the triangular teeth face outward.
Hold the ratchets on the transducer knuckle with one hand and fit the pivot arm over them until it snaps into place with the other hand. Refer to the illustration.
Ratchet
Rib at position 1
Ratchets Placed in Position 2 | Fitting the Pivot Arm Over the Ratchet |
Measuring the Transom Angle
Plumb 
line
Rib
Bead
Ratchet
Transom
Angle in degrees
(°)
12”
Measured Weight Distance (X)
16
