Husqvarna 11 C Adjusting the parking brake Rider 16 AWD, Adjusting the throttle wire, Maintenance

Maintenance

Adjusting the parking brake Rider 16 AWD

Check that the parking brake is adjusted correctly by placing the machine on a slope with the front and rear axles disengaged. Apply and lock the parking brake. When the machine does not stand still, the parking brake should be adjusted according to the following.

1Remove the left-hand wing cover.

1Loosen the locking nuts (1).

2Tension the cable using the adjuster screw (2) until the play in the cable is taken up.

3Tighten the locking nuts (1).

4The brake should be checked again after adjustment

5 Assemble the left-hand wing cover.

WARNING! A poorly adjusted parking brake

!can result in reduced braking ability.

Adjusting the throttle wire

The throttle cable may need to be adjusted, if the engine does not respond as it should when accelerating, if it produces black smoke or maximum revs are not reached.

1Release the clamping screw that secures the wire casing and set the choke control to maximum choke.

2Pull the choke wire casing to the far right and tighten the clamping screw.

3Pull back the throttle to the full throttle position and check that the choke is no longer actuated.

Replacing the air filter

If the engine seems to lack power or does not run smoothly this may be because the air filter is clogged. It is therefore important to replace the air filter at regular intervals (see Maintenance/Maintenance Schedule for the correct service interval).

Replace the air filter as follows:

1Open the engine cover.

2Pull up the handle on the air filter cover, unhook and turn towards the engine.

3Remove the air filter cover.

English – 23