Rider 13 C
Rider 11 C
Rider 16 AWD
Rider 16 C
Contents
CONTENTS
CONTENTS
Service journal
Dear Customer
INTRODUCTION
Driving and transport on public roads
Towing
INTRODUCTION
Good service
Serial Number
After the first 5 hours
Service journal
Pre-delivery service
Symbols
KEY TO SYMBOLS
Drive very slowly if no cutting unit is fitted Starting instructions
KEY TO SYMBOLS
Check the engine’s oil level Check the hydrostat’s oil level
Lift up the cutting unit Apply and lock the parking brake
Safety instructions
SAFETY INSTRUCTIONS
Insure your Rider
General use
This is what you do
Driving on slopes
WARNING! You must use approved personal
IMPORTANT INFORMATION
WARNING! The battery contains lead and
Maintenance
Children
WARNING! The engine and the exhaust
IMPORTANT INFORMATION
Transport
SAFETY INSTRUCTIONS
Location of the controls
WHAT IS WHAT?
Presentation
PRESENTATION
Clutch pedal, Rider 11 C
Brake pedal / Parking brake
Exercise care and refuel outdoors see safety instructions
Cutting height adjustment lever
Cutting unit
Lifting lever for the cutting unit
Release lever Rider 16 AWD
Release lever Rider 13 C, Rider 16 C
Clutch control, rear axle
Clutch control, front axle
Before starting
Driving
Start the engine
IMPORTANT INFORMATION
Connecting the jump leads
Starting the engine with a weak battery
Remove the cables in the reverse order
WARNING! Never run the engine indoors, in
Cutting tips
Driving the Rider
2 For Rider 13 C, Rider 16 AWD and Rider 16 C
3 For Rider 11 C
Stop the engine
Starting on a slope, manual gearbox, Rider 11 C
WARNING! Do not use the machine on
Driving
Maintenance schedule
Maintenance
Maintenance interval
The engine is switched off The ignition key is removed
Checking and adjusting the steering wires
Cleaning
Removing of the machine hoods
Engine cover
Adjusting the parking brake Rider 13 C, Rider 16 C
Adjusting the brake Rider 11 C
WARNING! A poorly adjusted brake can
Checking the brake Rider 11 C
Adjusting the throttle wire
Adjusting the parking brake Rider 16 AWD
WARNING! A poorly adjusted parking brake
Replacing the air filter
Checking the fuel pump’s air filter
Replacement of fuel filter
Checking the tyre pressure
Maintenance
WARNING! Procedures on contact with acid
Check the level of the battery acid
Ignition system
Fuses
Maintenance
Check the safety system
English
Maintenance
Rider 13 C, Rider 16 C Rider 16 AWD
Checking and adjustment of the cutting unit’s ground pressure
Adjusting the parallelism of the cutting unit
when the engine is running. Mind your fingers
Checking the engine’s cooling air intake
Maintenance
Service position for the cutting unit
Placing in the service position
Checking the blades
Restoring from service position
Removing the BioClip plug
WARNING! If the blades are cracked
Checking the engine’s oil level
Lubrication
Replacing the engine oil
WARNING! Engine oil can be very hot if it is
Lubrication Rider 11 C
Lubricating the belt adjuster
General lubrication
Rider 16 AWD
Procedure
Troubleshooting schedule
Problem
Storage
Service
Winter storage
Guard
Dimensions
TECHNICAL DATA
Rider 11 C
Engine
TECHNICAL DATA
Rider 13 C
Dimensions
Rider 16 AWD
Electrical system
Rider 16 C
TECHNICAL DATA
Dimensions
TECHNICAL DATA
´z+S!¶6¶¨ 38 - English ´z+S!¶6¶¨
EC-declaration of conformity Applies to Europe only
Page
1151019-26
´z+S!¶6¶¨ ´z+S!¶6¶¨