Rider 16 AWD
Rider 11 C
Rider 13 C
Rider 16 C
CONTENTS
CONTENTS
Contents
Service journal
Driving and transport on public roads
INTRODUCTION
Dear Customer
Towing
Good service
Serial Number
INTRODUCTION
Service journal
Pre-delivery service
After the first 5 hours
KEY TO SYMBOLS
Symbols
Check the engine’s oil level Check the hydrostat’s oil level
KEY TO SYMBOLS
Drive very slowly if no cutting unit is fitted Starting instructions
Lift up the cutting unit Apply and lock the parking brake
Insure your Rider
SAFETY INSTRUCTIONS
Safety instructions
General use
WARNING! You must use approved personal
Driving on slopes
This is what you do
IMPORTANT INFORMATION
Children
Maintenance
WARNING! The battery contains lead and
WARNING! The engine and the exhaust
Transport
SAFETY INSTRUCTIONS
IMPORTANT INFORMATION
WHAT IS WHAT?
Location of the controls
Clutch pedal, Rider 11 C
PRESENTATION
Presentation
Brake pedal / Parking brake
Cutting unit
Cutting height adjustment lever
Exercise care and refuel outdoors see safety instructions
Lifting lever for the cutting unit
Clutch control, rear axle
Release lever Rider 13 C, Rider 16 C
Release lever Rider 16 AWD
Clutch control, front axle
Start the engine
Driving
Before starting
IMPORTANT INFORMATION
Remove the cables in the reverse order
Starting the engine with a weak battery
Connecting the jump leads
WARNING! Never run the engine indoors, in
2 For Rider 13 C, Rider 16 AWD and Rider 16 C
Driving the Rider
Cutting tips
3 For Rider 11 C
WARNING! Do not use the machine on
Starting on a slope, manual gearbox, Rider 11 C
Stop the engine
Driving
Maintenance interval
Maintenance
Maintenance schedule
The engine is switched off The ignition key is removed
Removing of the machine hoods
Cleaning
Checking and adjusting the steering wires
Engine cover
WARNING! A poorly adjusted brake can
Adjusting the brake Rider 11 C
Adjusting the parking brake Rider 13 C, Rider 16 C
Checking the brake Rider 11 C
WARNING! A poorly adjusted parking brake
Adjusting the parking brake Rider 16 AWD
Adjusting the throttle wire
Replacing the air filter
Checking the tyre pressure
Replacement of fuel filter
Checking the fuel pump’s air filter
Maintenance
Ignition system
Check the level of the battery acid
WARNING! Procedures on contact with acid
Fuses
Check the safety system
Maintenance
Maintenance
Rider 13 C, Rider 16 C Rider 16 AWD
English
when the engine is running. Mind your fingers
Adjusting the parallelism of the cutting unit
Checking and adjustment of the cutting unit’s ground pressure
Checking the engine’s cooling air intake
Service position for the cutting unit
Placing in the service position
Maintenance
Removing the BioClip plug
Restoring from service position
Checking the blades
WARNING! If the blades are cracked
Replacing the engine oil
Lubrication
Checking the engine’s oil level
WARNING! Engine oil can be very hot if it is
General lubrication
Lubricating the belt adjuster
Lubrication Rider 11 C
Rider 16 AWD
Troubleshooting schedule
Problem
Procedure
Winter storage
Service
Storage
Guard
Rider 11 C
TECHNICAL DATA
Dimensions
Engine
Dimensions
Rider 13 C
TECHNICAL DATA
Rider 16 AWD
TECHNICAL DATA
Rider 16 C
Electrical system
Dimensions
´z+S!¶6¶¨ 38 - English ´z+S!¶6¶¨
EC-declaration of conformity Applies to Europe only
TECHNICAL DATA
Page
´z+S!¶6¶¨ ´z+S!¶6¶¨
1151019-26