Driving the machine | Husqvarna 15V2 guide

DRIVING

Driving the machine

1. Release the parking brake by pressing down the brake pedal.

	2. Carefully press down one of the pedals until the	2	1
	correct speed is reached.	2


	To drive forwards: press down pedal (1).
	To reverse: press down pedal (2).

3. Select the required cutting height (1-9) with the cutting height lever.

To obtain a uniform cutting height it is important that the tyre pressures are equal on both front wheels 60 kPa/8.5 PSI.

English – 17

Image 19

Husqvarna 15V2 manual Driving the machine

Contents

English Rider Svenska Contents Towing IntroductionDear customer Travel and transport on public roads Serial number Good service Explanation of Symbols General use Safety Instructions Keep children away from the area to be mowed Proceed as follows Driving on slopes Children Maintenance Do not smoke when carrying out maintenance Transport Presentation PresentationLocation of the controls Parking brake Throttle controlChoke lever Speed limiter Lift lever for cutting unit Cutting unit Seat Lever for adjustment of cutting heightFuelling Before starting DrivingStarting the engine Driving Driving the machine Cutting tips Release lever Stopping the engine Hours Before start 100 200 MaintenanceMaintenance schedule Daily Maintenance interval Right-hand fender Removing the machine hoodsEngine hood Front hood Adjusting the brake Checking and adjustment of the steering wiresPoorly adjusted brakes can result in reduced braking power Checking and adjusting the choke wire Checking and adjustment of the throttle wireReplacing the fuel filter Varning Replacing the air filter Checking of the fuel pump’s air filter Check the level of the battery acidFitting the wrong spark plug type can damage the engine Inspecting the safety system Checking the tyre pressure Main fuseChecking the engine’s cooling air intake Observe caution to avoid trapping your hand Fitting the cutting unit Removing the cutting unit Installing BioClip Checking and adjusting the cutting unit’s ground pressure Replacing the cutting unit belt Adjusting the parallelism of the cutting unitBelt replacement on BioClip Checking the cutting unit’s parallelism Belt change on Combi Maintenance Placing in service position Service position for the cutting unit Maintenance Restoring from service position Checking the blades Removal of BioClip plug Combi Replacing the break-pin BioClip 90, Combi Checking the engine’s oil level Lubrication Changing the oil filter Changing the oil Checking the transmission’s oil level Lubricating the belt adjusterGeneral lubrication Problem Procedure Trouble Shooting Schedule Cover ServiceStorage Winter storage Technical Data EU declaration of conformity Only applies to Europe Pre-delivery service Service JournalWork done Work done Date, mileage, stamp, sign ´z+H-¶6-¨ English 114 01