MAINTENANCE
Main fuse
The fuse is located in a loose holder under the battery case cover, in front of the battery.
Type:
Do not use any other type of fuse when replacing.
A blown fuse indicates that the
Pull the fuse out of the holder when replacing.
The fuse is used to protect the electrical system. If it blows again shortly after replacing, then there is a short circuit which must be rectified before the machine is used again.
Checking the tyre pressure
The tyre pressure should be 60 kPa (0.6 kp/cm2/8.5 PSI) all round.
To improve driving the pressure on the rear tyres can be reduced to 40 kPa (0.4 kp/cm2/5.6 PSI).
The maximum tyre pressure is 100 kPa (1.0 kp/cm2/14 PSI).
IMPORTANT INFORMATION
Different tyre pressures on the front tyres will result in the blades cutting the grass at different heights.
Checking the engine’s cooling air intake
Clean the air intake grille in the engine cover behind the driver’s seat.
Fold open the engine cover.
Check that the cooling intake is free from leaves, grass and dirt.
Check the air duct, located on the inside of the engine cover, ensure it is clean and does not rub against the cooling air intake.
A blocked cooling intake will interfere with the
cooling of the engine, which can damage theAir intake grille engine.
WARNING!
The cooling air intake rotates when the engine is running. Mind your fingers.
Cooling air intake
English – 27
