Husqvarna 15V2 specification

MAINTENANCE

Checking and adjusting the cutting unit’s ground pressure

To achieve the best cutting results the cutting unit should follow the underlying surface without pres- sing too hard against it.

The pressure is adjusted with a screw on each side of the machine.

1. Check the air pressure in the tyres 60 kPa (0.6 kp/cm2/8.5 PSI).

2. Place the Rider on a flat surface.

3. Put the lifting lever in the mowing position.

4. Place a set of bathroom scales under the cutting unit’s frame (front edge) so that it rests on the scales. If necessary a block can be placed between the frame and scales so that the support wheels do not bear any weight.

5.Adjust the unit’s ground pressure by screwing in or out the adjusting screws located behind the front wheels on both sides.

The ground pressure should be between 12 and 15 kg (26.5-33 lb).

30 – English

Image 32

Husqvarna 15V2 manual Checking and adjusting the cutting unit’s ground pressure

Contents

Rider English Svenska Contents Introduction Dear customerTravel and transport on public roads Towing Good service Serial number Explanation of Symbols Safety Instructions General use Keep children away from the area to be mowed Driving on slopes Proceed as follows Maintenance Children Do not smoke when carrying out maintenance Transport Location of the controls PresentationPresentation Throttle control Choke leverSpeed limiter Parking brake Cutting unit Lift lever for cutting unit Fuelling Lever for adjustment of cutting heightSeat Starting the engine DrivingBefore starting Driving Driving the machine Cutting tips Stopping the engine Release lever Maintenance Maintenance scheduleDaily Maintenance interval Hours Before start 100 200 Removing the machine hoods Engine hoodFront hood Right-hand fender Poorly adjusted brakes can result in reduced braking power Checking and adjustment of the steering wiresAdjusting the brake Replacing the fuel filter Checking and adjustment of the throttle wireChecking and adjusting the choke wire Replacing the air filter Varning Fitting the wrong spark plug type can damage the engine Check the level of the battery acidChecking of the fuel pump’s air filter Inspecting the safety system Checking the engine’s cooling air intake Main fuseChecking the tyre pressure Fitting the cutting unit Observe caution to avoid trapping your hand Installing BioClip Removing the cutting unit Checking and adjusting the cutting unit’s ground pressure Adjusting the parallelism of the cutting unit Belt replacement on BioClipChecking the cutting unit’s parallelism Replacing the cutting unit belt Belt change on Combi Maintenance Service position for the cutting unit Placing in service position Maintenance Restoring from service position Checking the blades Replacing the break-pin BioClip 90, Combi Removal of BioClip plug Combi Lubrication Checking the engine’s oil level Changing the oil Changing the oil filter General lubrication Lubricating the belt adjusterChecking the transmission’s oil level Trouble Shooting Schedule Problem Procedure Service StorageWinter storage Cover Technical Data EU declaration of conformity Only applies to Europe Work done Service JournalPre-delivery service Work done Date, mileage, stamp, sign ´z+H-¶6-¨ English 114 01