Manuals / Husqvarna / Lawn and Garden / Lawn Mower

Husqvarna 15V2 Removing the machine hoods, Maintenance, Engine hood, Front hood, Left-hand fender

Models: 15V2

1 52

Download 52 pages 29.65 Kb

Page 23

Image 23

MAINTENANCE

Removing the machine hoods

Engine hood

The engine is accessible for servicing when the engine hood is lifted up.

Tilt the seat forward, release the rubber strap under the seat, and tilt the hood backwards.

Front hood

Release the clip on the front hood and lift off the hood.

Right-hand fender

Remove the knob (1), the screws (2 and 3) and lift off the fender.

Left-hand fender

Release the screws in the fender (2) and lift off the fender.

English – 21

Page 23

Image 23

Husqvarna 15V2 manual Removing the machine hoods, Maintenance, Engine hood, Front hood, Right-hand fender, Left-hand fender

Contents

English RiderOperator´s manual Svenska CONTENTS Operator’s Manual for Rider Towing INTRODUCTIONDear customer Travel and transport on public roadsINTRODUCTION Good serviceSerial number EXPLANATION OF SYMBOLS Read the operator’s manual before starting the machine SAFETY INSTRUCTIONSSafety instructions General useNever leave the machine unsupervised with the Keep children away from the area to be mowedPersonal protective equipment SAFETY INSTRUCTIONSSAFETY INSTRUCTIONS Be especially careful when driving on slopesDriving on slopes Mow upwards and downwards on slopes, not sidewaysNever fill the fuel tank indoors MaintenanceChildren Never allow children to operate the machineRisk of burn injuries if touched Do not smoke when carrying out maintenanceSAFETY INSTRUCTIONS The engine and the exhaust system become very hot during operationSAFETY INSTRUCTIONS Regularly clean grass, leaves and other debris from the machineTransport Never run the machine in an enclosed areaLocation of the controls PRESENTATIONPresentation Parking brake Throttle controlChoke lever Speed limiterLowering of the cutting unit cutting position Cutting unitLift lever for cutting unit Lifting of the cutting unit transport positionPRESENTATION Lever for adjustment of cutting heightSeat FuellingStarting the engine DRIVINGBefore starting DRIVING 6. Push the choke lever gradually forward when the engine has startedDRIVING Driving the machineDRIVING Cutting tipsDRIVING Stopping the engineRelease lever Maintenance schedule MAINTENANCEFront hood Removing the machine hoodsMAINTENANCE Engine hoodPoorly adjusted brakes can result in reduced braking power Checking and adjustment of the steering wiresAdjusting the brake MAINTENANCEMAINTENANCE Checking and adjustment of the throttle wireChecking and adjusting the choke wire Replacing the fuel filterMAINTENANCE Replacing the air filterMAINTENANCE Check the level of the battery acidIgnition system Checking of the fuel pump’s air filter26 - English Inspecting the safety systemMAINTENANCE Cooling air intake Main fuseChecking the tyre pressure Checking the engine’s cooling air intakeObserve caution to avoid trapping your hand Fitting the cutting unitMAINTENANCE MAINTENANCE Installing BioClipRemoving the cutting unit MAINTENANCE Checking and adjusting the cutting unit’s ground pressureMAINTENANCE Adjusting the parallelism of the cutting unitChecking the cutting unit’s parallelism Replacing the cutting unit belt32 - English MAINTENANCEMAINTENANCE Placing in service position Service position for the cutting unitMAINTENANCE 5. Disengage the spring for the drive belt tensioning wheel MAINTENANCE8. Lift off the drive belt 1. Then pull out the pin MAINTENANCECutting unit with side ejection Checking the bladesBioClip Combi Combi Cutting unit with rear ejectionRemoval of BioClip plug Service positionReplacing the break-pin BioClip 90, Combi Removal of BioClip plug CombiChecking the engine’s oil level LUBRICATIONLUBRICATION Changing the oilChanging the oil filter LUBRICATION Lubricating the belt adjusterChecking the transmission’s oil level General lubricationProcedure TROUBLE SHOOTING SCHEDULEProblem Cover ServiceSTORAGE Winter storageEngine TECHNICAL DATADimensions RiderEU declaration of conformity Only applies to Europe Pre-delivery service SERVICE JOURNALEnglish SERVICE JOURNALWork done Date, mileage, stamp, signSERVICE JOURNAL ´z+H-¶6-¨Page 114 ´z+H-¶6-¨ 2002W45