MAINTENANCE
Fitting the cutting unit
WARNING!
Wear protective glasses when fitting the cutting unit. The collet spring which tensions up the belt can go off and cause personal injury.
1.Place the Rider on a flat surface and apply the parking brake. Check that the lever for setting the cutting height is in the lowest position.
Make sure the support wheels are fitted to the cutting unit (1).
2.Grasp the handle at the front or hold the frame of the cutting unit (2) and slide the unit underneath the rider mower.
Make sure that the tongue (3) on the cutting unit engages correctly.
3. Insert the bolt and secure it with a locking pin.
WARNING!
Observe caution to avoid trapping your hand.
4.Press down the frame and insert the pin. Fit the drive belt around the drive wheels of the cutting unit.
5.Hook up the height adjustment strut.
3
1
2
28 – English
