MAINTENANCE
The cutting unit components
In the instructions below, a cutting unit with a rear ejector is shown, but the same principles apply to all cutting units unless otherwise stated.
The components mentioned are:
•A Catch
•B Inner pin
•C Catch guard
•D Handle
•E Height adjustment strut
•F Parallelism strut
•G Lowest height adjustment stop
Attaching the cutting unit
WARNING!
Exercise caution.
Risk of crush injuries
Starting point for attaching the cutting unit:
•Place the machine on a flat surface.
•Lock the brake by pressing down the pedal and locking with the
•Equipment hydraulics in the lower position (PF 21).
•Equipment frame in lowered position.
•Equipment frame locked with safety catch and locks
(A) in the inset position.
•Unit frame mounted on the cutting unit, see “Removing the unit frame” on page 55.
D E
C 
B 
A F G
A
