Husqvarna ProFlex 21 manual Adjusting the hydrostatic transmission cable, Cable holder

Models: ProFlex 21

1 96
Download 96 pages 8.4 Kb
Page 39
Image 39

MAINTENANCE

Adjusting the hydrostatic transmission cable

The hydrostatic transmission cable (on the left side) is adjusted in the following manner:

1.Remove the transmission cover. Loosen both screws (one on each side) and lift off the transmission cover.

2.Take apart the lower ball joint, which is locked with a locking spring.

3.Ensure that the forward drive pedal is pressed down completely.

4.Switch the vertical arm to the maximum position and check that the ball and socket in the lower ball joint are aligned.

5.Adjust the socket on the cable if needed.

6.Assemble the lower ball joint.

7.Put the ball joint’s locking spring in place.

6008-209

6020-002

Cable holder

The cable seat in the middle protects the cables and the hydraulic tubes so that they do not get pinched during turns. It is situated close to the ground and can be damaged by objects or careless driving, especially when reversing.

Check to ensure that it is undamaged and that the belt guide is properly centred on the rear side of the pulley.

8009-364

English-37

Page 39
Image 39
Husqvarna ProFlex 21 manual Adjusting the hydrostatic transmission cable, Cable holder