LUBRICATION
10. Hydraulic oil filter, change, PF 21
IMPORTANT INFORMATION
Used engine or transmission oil is health- impairing and must not be disposed of in the ground or in nature.
Replaced filters must be handed in to the workshop or other allotted placed for disposal. Avoid skin contact; wash with soap and water in case of spills.
1.Remove the oil filter. If necessary, use a filter remover.
2.Wipe new, clean engine oil onto the seal for the new filter.
3.Fit the filter by hand with + 3/4 turn.
4.Remove the transmission cover and fill the transmission’s oil tank, about 0.3 l oil.
See “13. Transmission oil level” on page 69. Be observant when running the engine as described below and fill so that the tank is not emptied.
5.Run the engine warm, manipulate the equipment lift and power steering, and then check that there are no leaks around the oil filter seal.
6.Check the oil level in the transmission, top up if necessary. The oil filter holds 0.3 litres of oil.
7.Replace the transmission cover.
11. Oil filter, change
IMPORTANT INFORMATION
Used engine or transmission oil is health- impairing and must not be disposed of in the ground or in nature.
Replaced filters must be handed in to the workshop or other allotted placed for disposal. Avoid skin contact; wash with soap and water in case of spills.
1.Open the engine cover.
2.Drain the engine oil as described in “4. Engine oil” on page 64.
3.Remove the oil filter. If necessary, use a filter remover.
4.Wipe new, clean engine oil onto the seal for the new filter.
5.Fit the filter by hand with + 3/4 turn.
6.Run the engine warm, then check that there are no leaks around the oil filter seal.
7.Check the oil level in the engine, top up if necessary. The oil filter holds 0.2 litres of oil.
