198 RS/6000 43P 7043 Models 150 and 260 Handbook
historical comparison can be useful to System Administrators and service
personnel.
7.5.3.2 Read Progress Indicators from Last System Boot
Displays the boot progress indicators (check points), up to a maximum of
100, from the system boot prior to the one in progress now. This historical
information may be useful to help diagnose system faults.
7.5.3.3 Read Service Processor Error Logs
Displays error conditions detected by the Service Processor.
7.5.3.4 Read System POST Errors
Selecting this item lets you review the results of the POST (Power-On Self
Test). Your system unit may be able to start in the presence of POST errors if
there is sufficient working system resources.
7.5.3.5 Read NVRAM
Displays non-volatile random access memory (NVRAM) contents. The SP will
prompt you for an address. Enter 0 as a start address or any other.
7.5.3.6 Read Service Processor Configuration
The following menu shows you a summary of all SP settings. You are not able
to change anything in these three screens. To change the settings you have
to go into the different menus.
Current Service Processor Configuration
SYSTEM POWER CONTROL MENU
1. Enable/Disable Unattended Start Mode: Currently Disabled
6. Enable/Disable Fast System Boot: Currently Enabled
OS Surveillance Setup Menu
1. Surveillance: Currently Disabled
2. Surveillance Time Interval: Not Applicable
3. Surveillance Delay: Not Applicable
Ring Indicate Power-On Menu
1. Ring indicate power-on: Currently Disabled
2. Number of rings: Currently 6
Reboot/Restart Policy Setup Menu
1. Number of reboot attempts: Currently 3
2. Use OS-Defined restart policy? Currently Yes
3. Enable supplemental restart policy? Currently No
4. Call-Out before restart: Currently Disabled
(Press Return to Continue)