Installing memory, Installing DIMMs | IBM Partner Pavilion 6825

See the following illustration for the location of parts on the system board.

Microprocessor	Battery
DIMM connectors (1, 2, 3 left to right)	SCSI LED connector
Front panel connector	PCI slots
Power connector	Front panel audio connector
Diskette drive connector	CD-ROM audio connector
Primary IDE connector	AGP slot
Secondary IDE connector	12V Power connector
Clear CMOS/Recovery jumper

Installing memory

Your computer has three connectors for installing dual in-line memory modules (DIMMs) that provide up to a maximum of 1 GB of system memory.

Note: Your computer will only support DIMM 1 and DIMM 2 (from left to right). DIMM 3 will not be used due to mechanical restrictions.

When installing DIMMs, the following rules apply:

vFill each system memory connector sequentially, starting at DIMM 1

vUse 3.3 V, synchronous, 168-pin, unbuffered, 133 MHz, nonparity, synchronous dynamic random access memory (SDRAM)

vUse 64 MB, 128 MB, 256 MB, or 512 MB DIMMs in any combination

vDIMM heights of 38.1 mm (1.5 inches)

To install a DIMM:

1. Remove the cover. See “Removing the cover” on page 17.

Chapter 3. Installing internal options — small desktop model 19