42
Maintenance
F
IGURE 35
Removing the lens
To replace a lens:
1Make sure the latch is pointing down.
2Squeeze the latch and gently push the lens in until it stops,
then turn the lens clockwise until the catch is engaged.
Using the Zoom Lens
CAUTION: Be sure to fully
retract the zoom lens before you
put the lens cap on and pack th e
projector in its case.
The zoom lens enlarges the projected image by 40% without
moving the projector. (For more information about image size,
see “Projected Image Size” on page64.) Follow the previous
instructions to install the zoom lens.
Follow these steps when operating the zoom lens:
1Turn the zoom ring (Figure 36) until the projected image is the
size you want, even if it is out of focus.
2Turn the focus ring as needed to clear up the image.
FIGURE 36
LitePro 200 Series zoom lens
focus ring z oom ring