Integra DTR-5.2 Connect to devices with z terminals, Power on/ready function, Power off function

Connections

Connect to devices with z terminals

The z terminal on the DTR-5.2 is for connecting other Integra/ Onkyo components equipped with the same z terminal. When a component are z-connected, you can point the remote controller supplied with the DTR-5.2 at the sensor on the DTR-5.2 and operate that component without having to switch remote controllers.

In addition, by connecting components to the z terminal, you can also perform the system operations given below.

Power on/ready function

When the DTR-5.2 is in the standby state, if an z-connected component is turned on, then the DTR-5.2 also turns on and the input source selected at the DTR-5.2 automatically switches to that component.

If the power cord for an z-connected component is connected to the AC OUTLET on the DTR-5.2, or if the DTR-5.2 is turned on, this function will not work.

Direct change function

When the play button is pressed at an z-connected component, the input source selected at the DTR-5.2 automatically changes to that component.

Power off function

When the DTR-5.2 is placed in the standby state, all z-connected components are also automatically put into the standby state.

CAUTION

If an MD recorder is connected to the TAPE jack on the DTR-5.2, switch the Input Selector from TAPE to MD (see page 18).

DTR-5.2

REMOTE

CONTROL

zconnector

Ex: Integra/Onkyo CD player

zconnector

Ex: Integra/Onkyo cassette tape deck

To connect components using the z terminal, simply connect a remote control cable from this zterminal to the z terminal of the other component. An z remote control cable with a 1/8-inch (3.5-

mm)miniature two-conductor plug comes with every cassette tape deck, compact disc player, MD recorder, and DVD player that has an z terminal.

•For remote control operation, the audio connection cables must also be connected.

•The RC-441M remote controller does not support turntables.

•If a component has two z terminals, you can use either one to connect to the DTR-5.2. The other one can be used to daisy chain with another component.

•With Integra/Onkyo DVD players, you can enter the pre- program code so that you can operate the DVD player directly with the remote controller without connecting the z terminals (see page 38).

Connect to devices with multichannel output

By connecting a DVD player, MPEG decoder, or other component that has a multi channel port, you can playback the audio with 5.1 channel output. So, be sure to prepare a cable that can properly connect the DTR-5.2 to the peripheral device.

DTR-5.2 MULTI CHANNEL INPUT

	FRONT SURR	CENTER	OPTICAL	COAX
	L	1		2
GND
	R	SUB
SUBWOOFER	MULTI	WOOFER
			DIGITAL INPUT
PRE OUT CHANNEL INPUT

L (White) R (Red) R (Red) L (White)

Front output			Center output
Surround output		Subwoofer output
	DVD Player/MPEG decoder

Cautions regarding the AC OUTLETS connectors

The DTR-5.2 is supplied with AC mains outlets for connecting the power cords from other devices so that their power is supplied through the DTR-5.2. By doing this, you can use the Standby/On button on the DTR-5.2 to turn on and off the connected devices as well.

Caution:

Make sure that the total capacity of the other components connected to this unit does not exceed the capacity that is printed on the rear panel. For this model, the capcity is 120 watts.

AC OUTLETS

AC 120V 60 Hz

SWITCHED

TOTAL 120W 1 A MAX.

14