Operating components not reached by the remote controller signals (IR IN/OUT)
The following equipment (sold separately) is essential for operation:
•Onkyo’s
•Multiroom A/V distribution and control systems from Niles® and Xantech® to name a few
•Xantech is a registered trademark of Xantech Corporation.
•Niles is a registered trademark of Niles Audio Corporation.
If the remote controller signal does not reach other components
In this situation, you will need to use a commercially available IR emitter. Connect the IR emitter to the IR OUT terminal on the DTR-
5.2and then place the IR emitter on the remote sensor of the component or facing it. When the IR emitter is connected, only the signal input to the IR IN terminal is output to the IR OUT terminal. The signal input from the remote sensor on the front of the
If the remote controller signal does not reach the
If the
Connecting | IR Receiver |
block |
|
IR IN
IR OUT
IR Emitter
IR IN
Connecting block
IR Receiver
Remote Controller
other component
In the cabinet
: Signal flow
In the cabinet
Remote Controller
other component
: Signal flow
Remote control
: Signal folw
Make connection as shown below. Do not plug the equipment into the power source until the connection is complete.
Mini plug cable | From the connecting block |
|
|
| R |
| IR |
RS 232 | IN |
| |
| OUT |
| sensor | |
R |
|
|
| IR |
|
RS 232 | IN |
|
|
| |
| OUT | Mini plug cable |
|
| IR Emitter |
15