Integra DTR-5.2 appendix Using a Macro function

Using a Macro function

ON STDBY

ENTER

HOME THEATER CONTROLLER

RC-441M

Macro mode programming memo:

Erasing all commands and macros that have been programmed

This procedure will erase all the commands and macros that you have programmed into the remote controller and return it to its default settings. This operation will not affect the preset settings of the remote controller.

1.Open the battery cover and remove the batteries from the remote controller.

2.While pressing and holding down the ON and STDBY buttons, re-insert the batteries in their correct orientation, and then release both buttons.

The SEND/LEARN indicator flashes slowly.

3.Press the ENTER button.

The SEND/LEARN indicator lights up for about ten seconds and then turns off.

All programmed commands and macros are erased and the remote controller returns to its factory presets.

Notes:

•Proceed to Step 3 immediately after Step 2; otherwise, the batteries will be consumed quickly.

•If you press any button other than the ENTER button in Step 3, nothing will be erased. In this case, resume from Step 1.

MACRO	MODE	MODE	MODE	MODE	MODE	MODE	MODE	MODE	DIRECT
	MACRO	MACRO	MACRO	MACRO	MACRO	MACRO	MACRO	MACRO	MACRO
	↓	↓	↓	↓	↓	↓	↓	↓
	RCVR	CD	DVD	MD	SAT	CABLE	VCR	TV
Operation 1
Operation 2
Operation 3
Operation 4
Operation 5
Operation 6
Operation 7
Operation 8
Operation 9
Operation 10
Operation 11
Operation 12
Operation 13
Operation 14
Operation 15
Operation 16

48