Integra DTR-5.2 appendix Connecting the power, the receiver returns to Standby mode

Connecting the power

Standby indicator							ON	STDBY
Standby/on							RCVR MODE
Standby/On					A Speakers B	CH Level	Master Volume
					DSP/ Mode ADJ	Setup
Standby
						Return
Power
On Off					Push To Enter
	Display	Dimmer FM Mode Preset Memory	Tuning	Preset	Smart Scan Navigator
Phones	Audio					Bass	Treble
	Selector	DVDVideo 1 Video 2	Video 3	TapeFM	AMPhono	CD
		VCR
Power			To wall outlet

HOME THEATER CONTROLLER

RC-441M

•The DTR-5.2 is shipped with the main power (Power) switch in the on position ( On). When the power cord is plugged in for the first time, the DTR-5.2 will automatically enter the standby state and the Standby indicator will light (same condition after step 2 below).

•Before you plug in the DTR-5.2, confirm that all connections have been made properly.

•Turning on the power may cause a momentary power surge, which might interfere with other electrical equipment on the same circuit, such as computers. If this happens, use a wall outlet on a different circuit.

1. Plug the power cord into an AC wall outlet.

2. Press the Power switch to set the DTR-5.2 to standby state.

The Standby indicator will light up.

3. Press the Standby/On button to turn on the DTR-5.2. The display and four jog dial indicators will light up and the Standby indicator will turn off.

If you press the Standby/On button again,

the receiver returns to Standby mode. Turn off

Turning the power on from the remote controller:

Before you can use the remote controller, you must perform steps 1 and 2 above and place the DTR-5.2 in the standby state.

1. Press the RCVR MODE button.

The RCVR MODE button lights green.

2.Press the ON button to turn on the DTR-5.2 (take it out of the standby state).

To return the DTR-5.2 to the standby state, press the STDBY button.

To change the display of the input source from TAPE to MD:

If you connected an MD recorder to the TAPE jack on the DTR-5.2, you can have “MD” appear when the Tape source button is pressed. By changing the display, if an Onkyo MD recorder z-connected, the z system functions will become enabled.

Changing the display:

Press and hold down the TAPE source button until the display changes from TAPE to MD (approx. 3 seconds).

Tape

To return the display to its original setting, perform the same procedure. This setting is necessary to allow z system functions for the connected cassette tape or MD recorder.

Memory preservation

This unit does not require memory preservation batteries. A built- in memory power backup system preserves the contents of the memory during power failures and even when the Power switch is set to off. The Power switch must be set to on in order to charge the backup system.

The memory preservation period after the unit has been turned off varies depending on climate and placement of the unit. On the average, memory contents are protected over a period of a few weeks after the last time the unit has been turned off. This period is shorter when the unit is exposed to a highly humid climate.

18