Integra appendix Enjoying music or videos with the DTR-5.2, Selecting speakers Speakers A, B

Enjoying music or videos with the DTR-5.2

			Speakers A/B				Master Volume
	Display	Jog dial						SLEEP
						CH Level
								RCVR
								MODE
Standby/On					A Speakers B	CH Level	Master Volume
					DSP/ Mode ADJ	Setup		CH SEL	VOL
Standby
						Return		AUDIO	MUTING
Power
On Off					Push To Enter
	Display	Dimmer FM Mode Preset Memory	Tuning	Preset	Smart Scan Navigator
Phones	Audio					Bass	Treble		LEVEL
	Selector	DVDVideo 1 Video 2	Video 3Tape	FM	AMPhono	CD
		VCR
						Bass	Treble	SP A, B
	Audio Selector							DISPLAY

Selecting speakers (Speakers A, B)

Speakers A: This button turns on or off the speakers connected to the FRONT SPEAKERS, CENTER SPEAKER, SURROUND SPEAKERS, and SUBWOOFER terminals.

When you listen to surround audio or select multi channel input, be sure to turn on Speakers A.

When the speakers are turned on, the SPEAKERS A indicator lights up.

Speakers B: This button turns on or off the speakers connected to the FRONT SPEAKERS B terminals.

When the speakers are turned on, the SPEAKERS B indicator lights up.

Notes:

•You cannot select surround sound when you are using Speakers B.

•When using the B speakers, the A speakers can only be used for stereo or direct playback, so nothing will be output from the left and right surround speakers during multichannel playback.

Adjusting the volume

Adjusting the main volume adjusts the volume level output from all the speakers connected to the DTR-5.2 together. If headphones are connected, this also adjusts the volume heard from the headphone

speakers. To adjust the volume, either press the VOL buttons on the remote controller or turn the Master Volume dial. To increase the volume, turn the dial clockwise; to decrease the volume, turn the dial counterclockwise. The volume can be set to Min, 1 to 79, and Max.

HOME THEATER CONTROLLER

RC-441M

Switching the display

While listening to or watching an input source, you can display the information regarding the type of source and signal being input by pressing the DISPLAY button on the DTR-5.2 or the remote controller.

When an input source other than FM or AM is selected:

Input + volume

Program format*

Input + Listening mode or MULTI CH

*If the input signal does not have a program format, then this will be skipped.

When FM or AM is selected as the input source:

FM/AM frequency +
Preset no.	ch

FM/AM +

Listening mode

Adjusting the bass and treble

You can adjust the bass and treble levels using the Bass and Treble dials. This function only affects the front left and right speakers. For multichannel sources, these dials will not work if the tone control is set to “OFF.” (Refer to page 27.)

Temporarily turning off the sound (Remote controller only)

To turn off the sound momentarily, such as when interrupted by a phone call, press the MUTING button on the remote controller. When pressed, “MUTING” is displayed on the DTR-5.2. Press the MUTING button again to turn the sound back on.

Using the sleep time (Remote controller only)

The SLEEP button enables you to set the DTR-5.2 to turn off automatically after a specified time period. If you press it once, the DTR-5.2 will turn off after 90 minutes. Each time it is pressed thereafter, the remaining time until the DTR-5.2 turns off decreases by 10 minutes. While, the sleep function is enabled, you can press the SLEEP button to see how much time is left. To cancel the sleep function, press the SLEEP button when the time displayed is less than 10 minutes.

26