Integra DTR-7.6/6.6 instruction manual Turning On the AV Receiver, Turning On and Standby

DTR-7.6,6.6.book Page 37 Monday, September 26, 2005 1:40 PM

Turning On the AV Receiver

Standby/On		Standby
	Standby indicator	On

Receiver

Turning On and Standby

AV receiver	Remote
	controller

or

Press the [Standby/On] button.

Alternatively, press the remote controller’s [Receiver] button, followed by the [On] button.

The AV receiver comes on, the display lights up, and the Standby indicator goes off. Pressing the remote controller’s [On] button again will turn on any components con-

nected via .

To turn the AV receiver off, press the [Standby/On] button, or press the remote control- ler’s [Standby] button. The AV receiver will enter Standby mode. To prevent any loud surprises when you turn on the AV receiver, always turn down the volume before you turn it off.

Smooth Operation in a Few Easy Steps

To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver before you use it for the very first time. These settings only need to be made once.

■Do the automatic speaker setup—this is essential!

See “Automatic Speaker Setup” on page 38.

■Have you connected a component to an HDMI input, component video input, or digital audio input?

If you have, see “HDMI Video Setup (DTR-7.6 Only)” on page 41, “Component Video Setup” on page 42, or “Digital Audio Input Setup” on page 43 respectively.

■Have you connected an Integra MD recorder, CD recorder, or next generation HDD-compatible component?

If you have, see “Changing the Input Display” on page 44.

HDMI	Y
	PB	COAXIAL
	PR	OPTICAL
OUT IN
TAPE	CD recorder, MD recorder,
	RI Dock, etc.

37