Integra DTR-7.6/6.6 instruction manual 1 2, AV receiver is connected, First Time Setup, Notes

DTR-7.6,6.6.book Page 38 Monday, September 26, 2005 1:40 PM

First Time Setup

This section explains the settings that you need to make	2	Put the speaker setup micro-
before using the AV receiver for the very first time.
		phone in the listening position.

Automatic Speaker Setup

With the supplied speaker setup microphone, the Auto- matic Speaker Setup function can measure the test tone output by each speaker and automatically determine the number of speakers connected, the crossover frequency, the distance from each speaker to the listening position, and so on. Before using this function, connect and posi- tion all of your speakers.

1

2, 5

Microphone

Notes:

•Make sure the microphone is hori- zontal.

•If there’s an obstacle between the microphone and any speaker, the automatic setup will not work cor- rectly. Set up the room as you would when enjoying a DVD.

•Positioning the microphone close to where your ears would normally will provide better results. You can adjust the height of the microphone by using a tripod or level table.

Connect the setup microphone to the Setup Mic jack.

3, 4

Note: If any of yourspeakersis 4ohms, change the minimum speaker impedance setting before running the automatic speakersetup (see page 44).

Auto Speaker Setup

========================

Push Enter:Start

Caution! Loud sound.

Notes:

•If the AV receiver was previously muted, it will be unmuted.

•Automatic speaker setup cannot be performed while a pair of head- phones is connected.

1	Turn on the AV receiver and the
	connected TV.
	On the TV, select the input to which the
	AV receiver is connected.

38