Integra DTR-7.6/6.6 instruction manual Learning Commands from Other Remote Controllers, Notes

DTR-7.6,6.6.book Page 87 Monday, September 26, 2005 1:40 PM

Controlling Other Components—Continued

Learning Commands from Other Remote Controllers

The AV receiver’s remote controller can receive and learn commands from other remote controllers. By trans- mitting, for example, the Play command from your CD player’s remote controller, the remote controller can learn it and then transmit the exact same command when its Play [ ] button is pressed in the CD remote mode.

3	Point the remote controllers at
	each other, about 2 to 6 inches
	(5–15 cm) apart, and then press
	and hold the button whose com-
	mand you want to learn until the
	Remote indicator flashes.
	If the command is learned successfully,
	the Remote indicator flashes twice.

You can also use this function to learn individual com- mands after entering a remote control code (page 84).

Remote indicator

1

pe/AmReceiverp VCR

M

E

N

U

About 2 to 6 inches (5–15 cm)

On

V4

1

V1

Standby

4

V

7

CD

Multi

2

2

-

+

Phono

5

CH

V

TV

-/-

10

8 Tape

D

3

3

--

10

INPUT

1

0

6

VD

Input

Tuner

T

+

DVD

2Macro

Selector

11

Clear

9

- VCH

Remote

12

V

T

Mode

3

Vol

CD

Zone2

Cable

CDR

HDD

RC-621M

Sleep

MDSAT

CH- INPUT MULTI

									R
							VOLUME		MUTING
							TESTTONE		VEL
							SEL	CH
		PRESET
D	C			DVD					TAPE
		PHONO	TUNER
				GROUP
R		CTOR	SELETUNER
MODESU		DIMMER		2-	VIDEO	DC	DISC
			INPUT TAPE
						1-
			SLEEP		DVD	VIDEO
				POWER

1, 4

1	While holding down the Remote
	Mode button for the mode in
	which you want to use the com-
	mand, press the [On] button.
	The Remote indicator lights up.

2	On this AV receiver’s remote con-
	troller, press the button you want
	to learn the new command.

4	To learn more commands, repeat
	steps 2 and 3.
	Press any Remote Mode button when
	you’ve finished.

Notes:

•The following buttons cannot learn new commands:

Remote Mode, Macro [1], [2], [3], TV [ ], TV

[Input], TV CH [+]/[–], TV VOL []/[ ], Light.

•The remote controller can learn approximately 70-90 commands, although, this will be reduced by com- mands that use a lot of memory.

•Remote controller buttons such as Play, Stop, Pause, and so on are preprogrammed with commands for controlling Integra CD players, cassette decks, and DVD players. However, they can learn new com- mands, and you can restore the preprogrammed com- mands by resetting the remote controller (see

page 85).

•To overwrite a previously learned command, repeat this procedure.

•Only commands from infrared remote controllers can be learned.

•When the remote controller’s batteries expire, all learned commands will be lost and will have to be learned all over again, so don’t discard your other remote controllers.

87