Integra DTR-7.6/6.6 Digital Input Signal Formats, Advanced Setup-Continued, Setup closes

DTR-7.6,6.6.book Page 77 Monday, September 26, 2005 1:40 PM

Advanced Setup—Continued

Digital Input Signal Formats

Normally, the AV receiver detects the signal format auto- matically. However, if you experience either of the fol- lowing issues when playing PCM or DTS material, you can specify the signal format as either PCM or DTS:

•If the beginnings of tracks from a PCM source are cut off, try the PCM setting.

•If noise is produced when fast forwarding or rewind- ing a DTS CD, try the DTS setting.

Receiver

Enter

Setup

1	Press the [Receiver] Remote
	Mode button, followed by the
	[Setup] button.
	The main menu appears onscreen.

2	Use the Up and Down [ ]/[ ]
	buttons to select “2. Digital

Input,” and then press [Enter].

3	Use the Up and Down [		]/[	]
	buttons to select an input source
	that’s assigned to a digital input
	(opt, coax, or HDMI), and then
	press [Enter].
	The Digital Format menu appears.
	2-1.Digital Format
	------------------------
	a.DVD	:Auto
	b.VIDEO1	:Auto
	c.VIDEO2	:----
	d.VIDEO3	:Auto
	e.VIDEO4	:Auto
	f.TAPE	:----
	g.CD	:Auto
	h.PHONO	:----
4	Use the Up and Down [		]/[	]
	buttons to select the input, and
	use the Left and Right [		]/[	]
	buttons to select: PCM, DTS, or
	Auto.

PCM: The PCM indicator flashes, and only input signals in PCM format will be output.

DTS: The DTS indicator flashes, and only input signals in DTS format will be output.

Auto (default): The format is detected automatically. If no digital input signal is present, the corresponding analog input is used instead.

5	Press the [Setup] button.
	Setup closes.

Note:

•This procedure can also be performed on the AV receiver by using its [Setup] button, arrow buttons, and [Enter] button.

77