Intel 100BASE-TX manual

C H A P T E R 2 Intel Express 100BASE- TX Stackable Hub

CAUTION

The power cord is a North American type, UL-listed/ CSA-certified power supply cord. Immediately discard this cord if it is inappropriate for the electrical system of your country, and obtain the proper cord as required by your national electrical codes or ordinances.

2.Install any optional modules in the media adapter and/or expansion slots in the hub.

a.Remove the filler panel from the slot.

For instructions on removing filler panels, see “Installing and Removing Filler Panels” later in this chapter.

b.Install the module in the appropriate slot.

The media adapter fits into the media adapter slot. For instructions on installing a media adapter, refer to the documentation that shipped with your media adapter.

The NMM fits into the expansion slot. For instructions on installing an NMM, refer to the documentation that shipped with your NMM.

The 100BASE-TX Host Module fits into the expansion slot. For instructions on installing a 100BASE-TX Host Module, refer to the documentation that shipped with your host module.

3.Make the connections to the ports on the hub and optional installed media adapter and host module.

For instructions on making connections to ports, see “Making Connections to 100BASE-T Ports” in Chapter 3.

4.When installation for each unit in your stack is complete, connect the power cord(s) to the hub.

Connect the power cord(s), first to the power entry receptacle on the hub rear panel and then to the wall.

5.Verify the installation.

For instructions on verifying the installation, see “Verifying Installation” in Chapter 3.

16