Setting Up and Configuring the Development
environment. Since the board is not in a protective chassis, the user is required to observe extra precautions when handling and operating the system.
The board is a standard uBTX form factor and provides
The development kit includes eight hex standoffs and for screws to attach to the board for bench top use. Four of the standoffs are used to mount the heatsink (refer to Section 3.3 for heatsink installation). Attach standoffs to the screws to the board at the following mounting hole locations.
1.Insert screw through top mounting hole for the BTX Heatsink. Refer to Figure 17 for the mounting hole location.
2.Place standoff on backside of board and hand tighten to screw. Refer to Figure 18 for guide.
3.Repeat for additional standoffs on the board until all standoffs are installed. Refer to Figure 17 for recommended mounting hole locations.
Figure 17. Mounting Hole Locations
J24LB
Recommended
Mounting Hole
Locations
Mounting Hole for
BTX heatsink
Locations
| Intel® CoreTM 2 Duo Processor and Intel ® Q35 Express Chipset Development Kit |
October 2007 | User’s Manual |
Order Number: 318476001US | 27 |