User’s Manual
3.10Setting Jumpers
You can configure your board to match the needs of your application by setting jumpers. A jumper is the simplest kind of electric switch.
It consists of two metal pins and a small metal clip (often protected by a plastic cover) that slides over the pins to connect them. To “close” a jumper you connect the pins with the clip. To “open” a jumper you remove the clip. Sometimes a jumper will have three pins, labeled 1, 2, and 3. In this case, you would connect either two pins.
The jumper settings are schematically depicted in this manual as follows:
A pair of
If you have any doubts about the best hardware configuration for your application, contact your local distributor or sales representative before you make any changes.