Intel ECB-865 user manual Signal Description Parallel Port Connector J11, Stb#

ECB-865

3.11.13Signal Description – Parallel Port Connector (J11)

The following signal description covers the signal definitions, when the parallel port is operated in standard centronic mode. The parallel port controller also supports the fast EPP and ECP modes. Please refer to reference 2 for further information.

PD7..0	Parallel data bus from PC board to printer. The data lines are able to operate in PS/2
	compatible bi-directional mode.
SLIN#	Output line for detection of printer selection. This pin is pulled high internally.
SLCT	An active high input on this pin indicates that the printer is selected. This pin is pulled high
	internally.
STB#	An active low output is used to latch the parallel data into the printer. This pin is pulled high
	internally.
BUSY	An active high input indicates that the printer is not ready to receive data. This pin is pulled
	high internally.
ACK#	An active low input on this pin indicates that the printer has received data and is ready to
	accept more data. This pin is pulled high internally.
INIT#	Output line for the printer initialization. This pin is pulled high internally.
AFD#	An active low output from this pin causes the printer to auto feed a line after a line is printed.
	This pin is pulled high internally.
ERR#	An active low input on this pin indicates that the printer has encountered an error condition.
	This pin is pulled high internally.
PE	An active high input on this pin indicates that the printer has detected the end of the paper.
	This pin is pulled high internally.

3.11.14Box Header Serial Port 1 / Serial Port 2 Connector in RS-232 (J9, J12)

Signal		PIN		Signal
DCD	1		2	RxD
TxD	3		4	DTR
GND	5		6	DSR
RTS	7		8	CTS
RI	9		10	NC

ECB-865 User’s Manual 35