P3 Series | User's Manual |
|
|
2.3 Installation of the CPU and CPU Cooler
Before installing the CPU, please comply with the following conditions:
1.Please make sure that the mainboard supports the CPU.
2.Please take note of the one indented corner of the CPU. If you install the CPU in the wrong direction, the CPU will not insert properly. If this occurs, please change the insert direction of the CPU.
3.Please add an even layer of heat sink paste between the CPU and CPU cooler.
4.Please make sure the CPU cooler is installed on the CPU prior to system use, otherwise overheating and permanent damage of the CPU may occur.
5.Please set the CPU host frequency in accordance with the processor specifications. It is not recommended that the system bus frequency be set beyond hardware specifications since it does not meet the required standards for the peripherals. If you wish to set the frequen- cy beyond the proper specifications, please do so according to your hardware specifications including the CPU, graphics card, memory, hard drive, etc.
2.3.1 Installation of the CPU
1.Open the socket lever by pushing the lever down and away from the socket (see Figure 1, 1 and 2).
Figure 1
4. Remove the processor f r o m t h e p r o t e c t i v e processor cover. Hold the processor only at the edges, being careful not to touch the bottom of the processor (see Figure 4) . Do not discard the protective processor cover. Always re p l a c e t h e p r o c e s s o r back to the package if the processor is removed from the socket.
6.Pressing down on the load plate (Figure 6, 9)
c l o s e a n d e n g a g e t h e socket lever (Figure 6, 10).
2.Lift the load plate. Do not touch the socket contacts (see Figure 2, 3 and 4)
Figure 2
Figure 4
Figure 6
3 . Remove the plastic protective socket cover from the load plate (see Figure 3, 5). Do not discard the protective socket cover. Always replace the socket cover if the processor is removed from the socket.
Figure 3
5.Hold the processor with your thumb and index fingers oriented as shown in Figure 5. Make sure fingers align to the socket cutouts (see Figure 5, 6). Align notches (see Figure 5, 7) with the socket see (Figure 5, 8). Lower the processor straight down without tilting or sliding the processor in the socket.
Figure 5
- 13 -
